| Model | Size | Packing | Color |
| AMAX002 | 5.0cm*360cm | 10bags/box 12boxes/ctn | White, Green, Red and Yellow |
| AMAX003 | 7.5cm*360cm | 10bags/box 12boxes/ctn | |
| AMAX004 | 10cm*360cm | 10bags/box 9boxes/ctn | |
| AMAX005 | 12.5cm*360cm | 10bags/box 9boxes/ctn | |
| AMAX006 | 15cm*360cm | 10bags/box 9boxes/ctn |
|
Forearm
|
|
Upper Arm
|
|
Shank
|
|
Thigh
|
|
Lower limb
|
Method of use
A: Wear surgical gloves, select the roll of proper size. Apply stockinet or protective padding over the affected body part.
B: Open the package, immerse the roll of cast in room tempreture water(21℃-24℃) for 4-6 seconds, and squeeze 2-3 times to complete penetration of water into the roll, take it out and squeeze water off. (Tip: The tempreture of water is proportional to set time. The higher temperature shorten the set time, while the lower temperature lengthens it. Temperature of water warmer than 27℃, obviously shorten the set time, hardly for the surgery.)
C: Wrap cast spirally, overlapping the previous layer by one- half or two-thirds the width of the roll. Keep the proper tension and take care to avoid excessive tightness. Excessive looseness will affect the blood circulation of injured parts. (Tip: The Strength can be determined by the number of layers used. The more layers, the stronger. Just 3-4 layers provide a strong non-weight-bearing cast. Additional layers, need to keep a proper adhesion.)
D: Smooth and rub the surface to achieve good contact between layers. Finish the whole operation in 3-5 minutes. (Tip: Overtime will affect the adhesion and molding. Injured parts can not move before the sufficient cure of cast.)
